What it means
SELF DIAGNOSIS is not a failure. The coffee system shows it each time the main power button is switched on, then runs a self-test, preheat and rinse that cannot be interrupted. Press On/Standby once afterwards to wake it.
JennAir coffee machine SELF DIAGNOSIS / Start-up mode
SELF DIAGNOSIS is not a failure. The coffee system shows it each time the main power button is switched on, then runs a self-test, preheat and rinse that cannot be interrupted. Press On/Standby once afterwards to wake it.
Also shown as SELF DIAGNOSIS
SELF DIAGNOSIS is not a failure. The coffee system shows it each time the main power button is switched on, then runs a self-test, preheat and rinse that cannot be interrupted. Press On/Standby once afterwards to wake it.
JennAir says the self-diagnostic, preheat and rinse cycle cannot be interrupted.
SELF DIAGNOSIS repeats in a loop and the display never reaches standby.
Checks you have ticked / saved in this browser

JennAir says the self-diagnostic, preheat and rinse cycle cannot be interrupted.

With the main power button on, press On/Standby once, to the left of the coffee spout. HEATING UP Please wait appears.

Water may run off through the coffee spout.
JennAir says to use it only for vacation, storage or cleaning, and to unplug the unit before vacation or storage.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit



A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The coffee system shows it, and then shuts the message off, each time it is switched on at the main power button.
Read the supporting manualWith the main power button on, press On/Standby once. HEATING UP Please wait appears.
Read the supporting manualPress On/Standby again. TURNING OFF Please wait appears and hot water runs off.
Read the supporting manualIf SELF DIAGNOSIS never completes or loops without you touching the main switch, power or the control is at issue.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 2762 / PH 2762 (built-in coffee maker)
Scope: JennAir built-in coffee maker. Read from the JennAir Product Help message page for this code and checked against the overview page of display messages (November 2026).
It shows whenever the main power button is switched on. If you use only On/Standby, it should not repeat.
Press On/Standby once, on the left of the coffee spout. The display shows HEATING UP Please wait.
JennAir says automatically after 30 minutes, and Auto-Off in the Settings section changes that duration.
Yes. Hot water runs from the spout when the machine turns off or rinses.
Code or symptom, part, service call
GENERAL ALARM means the inside of the coffee system needs to be cleaned. JennAir says to clean the inside thoroughly; if the message still shows after cleaning, service is needed.
A display prompt halts brewing until you fix the condition: refill and seat the tank for FILL TANK, empty the grounds container, reseat the brewing unit, close the service door, or adjust a too-fine grind. DESCALE needs the descaling cycle. GENERAL ALARM means clean the inside.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.