What it means
F25 on a JennAir electric or induction cooktop says there is a problem with the power supply to the cooktop. Switch the breaker off for one minute and on again. If it reoccurs, JennAir says to contact a qualified electrician.
JennAir cooktop F25 / Power supply
F25 on a JennAir electric or induction cooktop says there is a problem with the power supply to the cooktop. Switch the breaker off for one minute and on again. If it reoccurs, JennAir says to contact a qualified electrician.
Also shown as F25
F25 on a JennAir electric or induction cooktop says there is a problem with the power supply to the cooktop. Switch the breaker off for one minute and on again. If it reoccurs, JennAir says to contact a qualified electrician.
A supply problem is a job for an electrician.
F25 returns after the reset.
Checks you have ticked / saved in this browser

Turn the cooktop breaker off, count a full minute, turn it on, and watch whether the code returns during the following minute.

A tripped or loose breaker elsewhere in the panel can matter. Do not open the panel yourself.

Does F25 appear at power-up, or only with several zones on?

Do not run the cooktop repeatedly with a supply problem.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
There is a problem with the power supply to the cooktop.
Read the supporting manualTurn the cooktop breaker off, count a full minute, turn it on, and watch whether the code returns during the following minute.
Read the supporting manualJennAir says to contact a qualified electrician.
Read the supporting manualF40 and F42 point at the power board and wiring. F25 points at the supply.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2022-03-24; PH 11904 / PH 11904 (electric and induction cooktop)
Scope: JennAir electric and induction cooktops (PH 11904).
There is a problem with the power supply to the cooktop, according to JennAir.
It can. Switch the breaker off for one minute, on again, and watch the cooktop for a minute.
JennAir says to contact a qualified electrician if the issue reoccurs. We can help find whether the cooktop or the supply is the cause.
No board is named on the F25 page. F40 and F42 are the board entries.
Code or symptom, part, service call
F61 on a JennAir electric or induction cooktop may involve the touch control (user interface), the power module, the wiring, or the electrical supply. Reset the breaker for one minute.
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.