What it means
F42 on a JennAir electric or induction cooktop may involve the board that powers the cooktop, or its wiring. Switch the breaker off for one minute, back on, and watch the cooktop for one minute.
JennAir cooktop F42 / Power control board
F42 on a JennAir electric or induction cooktop may involve the board that powers the cooktop, or its wiring. Switch the breaker off for one minute, back on, and watch the cooktop for one minute.
Also shown as F42
F42 on a JennAir electric or induction cooktop may involve the board that powers the cooktop, or its wiring. Switch the breaker off for one minute, back on, and watch the cooktop for one minute.
Power boards hold live parts.
F42 returns after the reset.
Checks you have ticked / saved in this browser

Cut the breaker for a minute, restore it, and run one zone while you watch for the board code to reappear.

Run one zone briefly to see if F42 returns.

The board is inside the cooktop. Leave it to a technician.

Start-up, high power, or after a boil-over?
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The power control board is the circuit board that feeds the elements in a JennAir cooktop, electric or induction.
Read the definitionJennAir points at the cooktop power control board or its wiring.
Read the supporting manualCut the breaker for a minute, restore it, and run one zone while you watch for the board code to reappear.
Read the supporting manualF40 adds the touchpad. F61 adds the touch control and the electrical supply.
Read the supporting manualIf F42 returns after the reset. Board work needs a technician.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2022-03-24; PH 11911 / PH 11911 (electric and induction cooktop)
Scope: JennAir electric and induction cooktops (PH 11911).
The board that powers the cooktop, or its wiring, may be the problem.
The F42 page does not list it. F40 and F61 do.
It might clear a one-off. If F42 returns, book a visit.
Do not keep using a cooktop that repeats the code.
Code or symptom, part, service call
F40 on a JennAir electric or induction cooktop may involve the touchpad (user interface), the board that powers the cooktop, or the wiring. Reset the breaker for one minute and watch the cooktop.
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
The power control board is the circuit board that feeds the elements in a JennAir cooktop, electric or induction. Two codes name it: F42 lists the board and its wiring, and F40 lists the touchpad as well. The only step JennAir gives is a sixty-second power-down.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.