What it means
With E23 the oven failed to reach preheat temperature in thirty minutes. JennAir lists the heater, the board that drives it, or the wiring. Turn the microwave breaker off for a minute, then on.
JennAir microwave E23 / Heating
With E23 the oven failed to reach preheat temperature in thirty minutes. JennAir lists the heater, the board that drives it, or the wiring. Turn the microwave breaker off for a minute, then on.
Also shown as E23
With E23 the oven failed to reach preheat temperature in thirty minutes. JennAir lists the heater, the board that drives it, or the wiring. Turn the microwave breaker off for a minute, then on.
Leave it off for a full minute, then switch it back on.
E23 returns after the reset.
Checks you have ticked / saved in this browser

Leave it off for a full minute, then switch it back on.

Check that E23 does not reappear in the first minute.

Verify operation. Do not leave a preheat running unattended if it was slow.
E23 belongs to a heating mode, not microwave-only cooking.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The oven did not reach preheat temperature within 30 minutes.
Read the supporting manualSwitch the microwave breaker off for a minute, turn it on and watch for E23 during that next minute.
Read the supporting manualThe page does not say so. Do not run a preheat unattended if it seems too slow.
Read the supporting manualWhen it returns after the reset. A heater or board problem needs testing.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9586 / PH 9586 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
The oven did not reach its preheat temperature within thirty minutes.
The heater, the board that drives it, and the wiring.
Roughly. E23 is too slow to heat. E24 is an overheat condition.
The page speaks of preheat temperature, so it relates to a heating mode of the oven.
Code or symptom, part, service call
With E24 the cavity registered an overheat reading of 500 F (260 C). JennAir lists the thermal sensor, the gas sensor, the board or the wiring. Turn the microwave breaker off for a minute and on again.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.