What it means
F3T4 says there may be a problem with the magnetron temperature thermistor or the associated wiring. Turn off the microwave breaker for a minute, turn it on, and keep the oven in view for a minute.
JennAir microwave F3T4 / Heating
F3T4 says there may be a problem with the magnetron temperature thermistor or the associated wiring. Turn off the microwave breaker for a minute, turn it on, and keep the oven in view for a minute.
Also shown as F3T4
F3T4 says there may be a problem with the magnetron temperature thermistor or the associated wiring. Turn off the microwave breaker for a minute, turn it on, and keep the oven in view for a minute.
One minute off, then back on.
F3T4 returns after the reset.
Checks you have ticked / saved in this browser

One minute off, then back on.

Check F3T4 does not return in the first minute.

Test with a short, safe cycle of water in a cup.
Never run a microwave with nothing inside while testing.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
There may be a problem with the magnetron temperature thermistor or the associated wiring.
Read the supporting manualTurn the breaker off for a minute, switch it on and stay nearby for a minute.
Read the supporting manualNever run a microwave empty to test it. Use a cup of water if you need a load.
Read the supporting manualWhen F3T4 returns. A thermistor on the magnetron needs testing in place.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9613 / PH 9613 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
The magnetron temperature thermistor, the sensor that follows the temperature of the part that makes the microwave energy.
The page does not say so. It names the thermistor and wiring.
E23 is a slow preheat. F3T4 is a sensor entry, but both concern heating.
After the reset, a brief test is fine. If F3T4 returns, stop and book.
Code or symptom, part, service call
F3T3 points at the thermistor that reads hood temperature, or at its wiring. Shut off the microwave breaker for a minute, switch it on, and keep the oven in view for a minute.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.