What it means
F3 E7 is another wall-oven-only row where JennAir lists the sensor, the control board, or the wiring between them. Cycle the breaker for 60 seconds, watch for a minute, and book if it returns.
JennAir oven F3E7 / Temperature sensor
F3 E7 is another wall-oven-only row where JennAir lists the sensor, the control board, or the wiring between them. Cycle the breaker for 60 seconds, watch for a minute, and book if it returns.
Also shown as F3E7
F3 E7 is another wall-oven-only row where JennAir lists the sensor, the control board, or the wiring between them. Cycle the breaker for 60 seconds, watch for a minute, and book if it returns.
Let the cavity cool on its own.
F3 E7 returns after the breaker reset.
Checks you have ticked / saved in this browser

Let the cavity cool on its own.

Use the circuit that serves the wall oven. Check the unit's rating label if you are unsure.

See whether the code appears during warm-up or only at higher heat.

How many minutes after preheat did F3 E7 show? That number helps a technician.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them.
Read the definitionIt follows E5 and E6 in the same wall oven list. All three use one wording, so the code is a flag to start from, not a unique diagnosis.
Read the supporting manualNo beyond the power cycle. The page lists the one-minute breaker off, power up, a minute of monitoring and a check that the oven works.
Read the supporting manualA sensor that fails at once usually shows up on preheat. One that fails under load may only appear at high temperature. That timing is our general advice, but it saves a technician's time.
Read the supporting manualIf it shows the code again, yes. Use the upper oven or a countertop appliance for the time being.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13341 / PH 13341 (wall oven)
PH 13341: F3E7, wall-oven.
The manufacturer groups related control events under one description. The digit is visible to a technician, not explained to owners.
No. The page lists a sensor, a control and wiring, all of which are repairable parts.
Treat that as an intermittent problem. Book a visit and mention both dates.
One short reset is routine. Repeated power cycling does not fix a failing part.
Code or symptom, part, service call
F3 on a JennAir freestanding range or wall oven points at the oven control or its wiring, and on a steam wall oven the page only asks for a breaker reset. Switch the oven breaker off for a single minute, switch it back on, then watch the display for another minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them. The sensor reports cavity heat to the control. The help pages pair it with the control, so one reset is the only owner step.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.