What it means
F3 E6 is a wall oven code that JennAir words exactly like E5, E7 and E8: lower oven temperature sensor, control or wiring. Reset at the breaker for 60 seconds and watch the display.
JennAir oven F3E6 / Temperature sensor
F3 E6 is a wall oven code that JennAir words exactly like E5, E7 and E8: lower oven temperature sensor, control or wiring. Reset at the breaker for 60 seconds and watch the display.
Also shown as F3E6
F3 E6 is a wall oven code that JennAir words exactly like E5, E7 and E8: lower oven temperature sensor, control or wiring. Reset at the breaker for 60 seconds and watch the display.
A reset in the middle of a roast ruins both the roast and the test.
F3 E6 returns on the next preheat.
Checks you have ticked / saved in this browser

A reset in the middle of a roast ruins both the roast and the test.

Then leave the oven idle for one more minute and watch.

Set a low-temperature bake in the lower cavity and see if the code stays away.

If the upper oven reports nothing, tell the technician that only the lower one is affected.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them.
Read the definitionJennAir's wall oven pages for these four use the same line. The manufacturer does not publish what the digit separates, so any claim about it would be a guess.
Read the supporting manualthe temperature sensor, the oven control or the cabling between them. It is a short list because the page expects a reset to settle most one-off events.
Read the supporting manualIf a bake runs clean after the reset, the trigger may have been momentary. If F3 E6 shows up again during preheat, something in that list is not working and testing is needed.
Read the supporting manualProduct Help does not break this row out by model year. Check the model tag and tell the technician; they can match it to the right parts.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13340 / PH 13340 (wall oven)
PH 13340: F3E6, wall-oven.
JennAir words them identically. Only a technician's reading of the control can say what separates them.
Do not buy parts from a code alone. The page lists three possibilities, and a meter test separates them.
JennAir gives no safety warning for it. The practical risk is wrong temperature, not shock, but the oven's reliability is in doubt.
Not necessarily. Write down the code before you reset.
Code or symptom, part, service call
F3 on a JennAir freestanding range or wall oven points at the oven control or its wiring, and on a steam wall oven the page only asks for a breaker reset. Switch the oven breaker off for a single minute, switch it back on, then watch the display for another minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them. The sensor reports cavity heat to the control. The help pages pair it with the control, so one reset is the only owner step.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.