What it means
F4 E1 names the thermistor, the appliance manager or the wiring on a JennAir wall oven; the page does not specify which cavity. Reset at the breaker for sixty seconds and watch for a minute.
JennAir oven F4E1 / Appliance manager
F4 E1 names the thermistor, the appliance manager or the wiring on a JennAir wall oven; the page does not specify which cavity. Reset at the breaker for sixty seconds and watch for a minute.
Also shown as F4E1
F4 E1 names the thermistor, the appliance manager or the wiring on a JennAir wall oven; the page does not specify which cavity. Reset at the breaker for sixty seconds and watch for a minute.
A thermistor reading during a hot cycle is not worth chasing.
F4 E1 returns after the breaker reset.
Checks you have ticked / saved in this browser

A thermistor reading during a hot cycle is not worth chasing.

Then watch the display for a full minute.

Run each briefly to see which side reports trouble.

The appliance manager differs between models.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls.
Read the definitionA thermistor changes resistance with temperature, so the control can read how hot something is. JennAir lists one here, along with the appliance manager.
Read the supporting manualIt is the board that coordinates the oven's functions. On a combination oven it can link the oven and microwave controls, so trouble there can show up in several ways.
Read the supporting manualE2 also lists the microwave sensor or thermistor and the microwave appliance manager. E1 drops the word microwave, so JennAir seems to point at the main side, but the page does not confirm it.
Read the supporting manualIf the code does not return, carry on gently. If it does, book a visit.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13347 / PH 13347 (wall oven)
PH 13347: F4E1, wall-oven.
No. It is soldered or plugged into harnesses that need testing.
If it started and holds temperature after a reset, a short bake is a reasonable test. Do not leave it unattended.
JennAir lists it as a possible trouble spot. A technician tests it.
Not for E1. E2 does.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls. The F6 family names it, sometimes with the converter control or the user interface. The pages admit there are many possible reasons, then give one reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.