What it means
F4 E2 on a JennAir wall oven names the microwave sensor or thermistor, the microwave appliance manager, or wiring. Reset the oven's breaker for about a minute and see if the microwave side stays clear.
JennAir oven F4E2 / Microwave (combination oven)
F4 E2 on a JennAir wall oven names the microwave sensor or thermistor, the microwave appliance manager, or wiring. Reset the oven's breaker for about a minute and see if the microwave side stays clear.
Also shown as F4E2
F4 E2 on a JennAir wall oven names the microwave sensor or thermistor, the microwave appliance manager, or wiring. Reset the oven's breaker for about a minute and see if the microwave side stays clear.
Make sure no food sits in the cavity during the reset.
F4 E2 returns after the reset.
Checks you have ticked / saved in this browser

Make sure no food sits in the cavity during the reset.

Restore power and observe the display.

If it clears, F4 E2 may have been a one-off.

Report exhaust noises to the technician.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls.
Read the definitionThe page lists a microwave sensor or thermistor and the microwave appliance manager. Together they tell the microwave how hot the cavity or exhaust is.
Read the supporting manualA microwave can overheat if the cavity temperature goes unmonitored. That is our reading of why the sensor exists; JennAir lists it only as a possible trouble spot.
Read the supporting manualF4 E3 names an exhaust air temperature sensor only. F4 E2 adds the microwave appliance manager.
Read the supporting manualIf the code returns, stay away until a technician has looked. A cooling sensor that fails can let a unit run hotter than designed.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13348 / PH 13348 (wall oven)
PH 13348: F4E2, wall-oven.
Possibly, but the page covers the microwave only. Test it separately.
JennAir gives no safety warning, but repeated sensor or control problems deserve a visit.
A control board that coordinates a section of the oven.
Do not; testing comes first.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls. The F6 family names it, sometimes with the converter control or the user interface. The pages admit there are many possible reasons, then give one reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.