What it means
F4 E7 names the microwave meat probe, its receptacle or the wiring on a JennAir wall oven. Take the probe out, inspect it, seat it fully if you use it, then reset the breaker for about a minute.
JennAir oven F4E7 / Microwave (combination oven)
F4 E7 names the microwave meat probe, its receptacle or the wiring on a JennAir wall oven. Take the probe out, inspect it, seat it fully if you use it, then reset the breaker for about a minute.
Also shown as F4E7
F4 E7 names the microwave meat probe, its receptacle or the wiring on a JennAir wall oven. Take the probe out, inspect it, seat it fully if you use it, then reset the breaker for about a minute.
If the microwave has just run, the probe may be hot.
F4 E7 returns after reseating the probe and resetting.
Checks you have ticked / saved in this browser

If the microwave has just run, the probe may be hot.

Look for bent pins, food residue or a cracked cable.

Push the probe all the way into its receptacle.

Watch the display for a minute afterward.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
Several JennAir F3 and F8 codes come from the meat probe.
Read the definitionThe microwave meat probe, the receptacle it plugs into, or the wiring. JennAir lists those three for F4 E7 on a combination wall oven.
Read the supporting manualF3 E4 is the probe row for the oven side of ranges and wall ovens. F4 E7 is specific to the microwave probe, so use the page that matches your display.
Read the supporting manualYes, if the oven runs without the code. Leave the probe out until it has been checked.
Read the supporting manualWhen F4 E7 persists after reseating and resetting. The receptacle and wiring are technician work.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13353 / PH 13353 (wall oven)
PH 13353: F4E7, wall-oven.
Probes are normally sold as separate accessories, but confirm the right one for your model with a technician.
Possibly. Clean the probe's plug gently with a damp cloth when it is cool and dry it fully.
The page does not say. Try a normal manual run after the reset.
No. It is wired into the cavity wall.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Several JennAir F3 and F8 codes come from the meat probe. The pages ask you to confirm the probe is seated in its receptacle, and on some wall ovens to check a power attachment on the roll-out rack. These are quick owner checks before any reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.