What it means
F4 E6 names the microwave wave guide temperature sensor or its wiring on a JennAir wall oven. Reset at the breaker for sixty seconds, and never run the microwave empty while you test it.
JennAir oven F4E6 / Microwave (combination oven)
F4 E6 names the microwave wave guide temperature sensor or its wiring on a JennAir wall oven. Reset at the breaker for sixty seconds, and never run the microwave empty while you test it.
Also shown as F4E6
F4 E6 names the microwave wave guide temperature sensor or its wiring on a JennAir wall oven. Reset at the breaker for sixty seconds, and never run the microwave empty while you test it.
Put a cup of water inside for any test run; an empty cavity can damage the unit.
F4 E6 returns after the reset.
Checks you have ticked / saved in this browser

Put a cup of water inside for any test run; an empty cavity can damage the unit.

Use the wall oven's own circuit, restore it, and wait a minute.

Thirty seconds on a cup of water is enough to see whether the code returns.

Do not keep trying; heat sensing is a protective function.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It is the metal channel that carries microwave energy from the magnetron into the cavity. JennAir lists a temperature sensor on that path for this code, or the wiring that serves it.
Read the supporting manualOverheating in the microwave path is something a control should notice. That is our general reading of why the sensor exists; JennAir lists it only as a possible trouble spot.
Read the supporting manualIf the code repeats, keep the microwave off until a technician has looked. The oven side is a separate matter and the page does not say whether it is affected.
Read the supporting manualF4 E3 names the exhaust air temperature sensor instead. Both are temperature readings, but in different places.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13352 / PH 13352 (wall oven)
PH 13352: F4E6, wall-oven.
No. It sits in a high-voltage area behind panels.
Not without removing covers, so do not look for it.
Water absorbs the microwave energy, protecting the unit during a short run.
Sometimes after a power reset. If it returns, it needs diagnosis.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.