What it means
F6 E7 names the microwave appliance manager or its wiring on a JennAir combination wall oven. Reset the breaker for about a minute, then check whether the microwave side starts.
JennAir oven F6E7 / Microwave (combination oven)
F6 E7 names the microwave appliance manager or its wiring on a JennAir combination wall oven. Reset the breaker for about a minute, then check whether the microwave side starts.
Also shown as F6E7
F6 E7 names the microwave appliance manager or its wiring on a JennAir combination wall oven. Reset the breaker for about a minute, then check whether the microwave side starts.
Remove food and containers before testing.
F6 E7 returns after the reset.
Checks you have ticked / saved in this browser

Remove food and containers before testing.

Restore power afterward.

If it starts and the code stays away, the glitch may have been momentary.

Run a short bake to see if only the microwave is affected.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls.
Read the definitionIt is the board that coordinates the microwave's power, door and display functions. JennAir lists it, or the wiring, for F6 E7.
Read the supporting manualOnly wall ovens that pair an oven with a microwave have a separate microwave manager. A single oven would not show it.
Read the supporting manualE8 reads almost the same but adds the word control. The pages give no further difference.
Read the supporting manualIf the reset holds and the microwave heats normally, you can. A repeat means stop and book.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-18; PH 13374 / PH 13374 (wall oven)
PH 13374: F6E7, wall-oven.
Possibly. Run a short bake to see whether the oven side heats, but do not assume it will, because JennAir's page does not say. Use the oven only if it behaves normally.
No. The microwave appliance manager is a control board, not a part an owner replaces. After the breaker reset, if the code returns, book a visit.
The page does not say that what you cooked matters. It lists the microwave appliance manager or its wiring, so tell the technician what you were doing when the code appeared.
F1 E3 names the same microwave manager under a different code. Both are listed for a combination wall oven, and JennAir's pages give no further difference between them.
Code or symptom, part, service call
F6 E8 lists the microwave appliance manager control or its wiring on a JennAir combination wall oven. Reset at the breaker for about a minute and test the microwave with a cup of water.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls. The F6 family names it, sometimes with the converter control or the user interface. The pages admit there are many possible reasons, then give one reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.