What it means
FC E9 repeats the Wi-Fi power module wording of E6 on a JennAir range or wall oven. Reset the breaker for about a minute; if the code returns, the module or its wiring needs a technician and the router is not the cause.
JennAir oven FCE9 / Wi-Fi hardware
FC E9 repeats the Wi-Fi power module wording of E6 on a JennAir range or wall oven. Reset the breaker for about a minute; if the code returns, the module or its wiring needs a technician and the router is not the cause.
Also shown as FCE9
FC E9 repeats the Wi-Fi power module wording of E6 on a JennAir range or wall oven. Reset the breaker for about a minute; if the code returns, the module or its wiring needs a technician and the router is not the cause.
If the display and heating are normal, only connected features are likely affected.
FC E9 returns after the reset.
Checks you have ticked / saved in this browser

If the display and heating are normal, only connected features are likely affected.

Restore power and give the oven time to start up.

This code names a part inside the oven, so network fixes will not help.

Tell the technician which, and give your model number.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The Wi-Fi module links a connected JennAir oven to your router.
Read the definitionThe Wi-Fi power module or the associated wiring, word for word as FC E6 does.
Read the supporting manualThe pages do not explain it. We will not guess at what the second number adds.
Read the supporting manualConnected features such as the app. JennAir's pages do not say baking or broiling is affected.
Read the supporting manualIf FC E9 returns after the reset. Wi-Fi hardware sits behind trim and is wired into the oven's control.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 13004 / PH 13004 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13248 / PH 13248 (wall oven)
PH 13004, 13248: FCE9, range/wall-oven.
The wording is identical, so the checks are the same.
No. It is an internal part wired to the oven's supply.
The page does not say it stops. Try a normal bake after the reset.
No safety warning is printed. Book at your convenience unless the oven also misbehaves.
Code or symptom, part, service call
JennAir prints no bare FC. FC E1 to E9 are connected-appliance codes on ranges and wall ovens: E1 to E3 and E7 say the oven could not reach your router, E4 and E5 name the Wi-Fi antenna, E6 and E9 the Wi-Fi power module, and E8 is a registration entry error. Start with the home network.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
The Wi-Fi module links a connected JennAir oven to your router. FC E1 to FC E3 mean the appliance could not connect; FC E4 and FC E5 name the antenna; FC E6 and FC E9 name the power module. A router restart is the first owner step; the oven itself still bakes.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.