What it means
Locked, Lock or Loc on a JennAir range or wall oven means the control lock is on: the pads are shut down and the door is locked to prevent unintended use. Touch and hold START/ENTER for five seconds to unlock.
JennAir oven Locked, Lock or Loc / Control message
Locked, Lock or Loc on a JennAir range or wall oven means the control lock is on: the pads are shut down and the door is locked to prevent unintended use. Touch and hold START/ENTER for five seconds to unlock.
Also shown as Locked, Lock or Loc
Locked, Lock or Loc on a JennAir range or wall oven means the control lock is on: the pads are shut down and the door is locked to prevent unintended use. Touch and hold START/ENTER for five seconds to unlock.
The lock can only be set with both off, and the same hold clears it.
The unlock hold does nothing.
Checks you have ticked / saved in this browser

The lock can only be set with both off, and the same hold clears it.

Keep your finger on it for five seconds.

It may take a moment.

Confirm the keys respond.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir's range page says the control lock shuts down the control pads and locks the oven door to prevent unintended use.
Read the supporting manualTouch and hold START/ENTER for five seconds. The oven and timer must be off to lock it.
Read the supporting manualJennAir prints a parallel page for the wall oven, so the behavior is the same.
Read the supporting manualIf the hold does nothing, or the door stays locked after the oven is cool.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-07; PH 13129 / PH 13129 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13255 / PH 13255 (wall oven)
PH 13129, 13255: LOCKED-LOCK-OR-LOC, range/wall-oven.
No. Locked is a feature of the control, not an error. It means the control lock is on, which shuts down the pads and locks the door to prevent unintended use.
JennAir says the lock is there to prevent unintended use. The pads are shut down and the door is held shut until you touch and hold START/ENTER for five seconds.
Yes, they are display variants of the same state. Locked, Lock or Loc all tell you the control lock is on, and the same five-second hold on START/ENTER clears it.
The page does not say. It describes the lock as something you set yourself by holding START/ENTER with the oven and timer off, so if it appears unprompted, try the unlock hold first.
Code or symptom, part, service call
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.