What it means
INSERT GROUNDS CONTAINER means the grounds container was not put back after cleaning. Open the service door and insert it, making sure it sits correctly on the drip tray.
JennAir coffee machine INSERT GROUNDS CONTAINER / Grounds and drip tray
INSERT GROUNDS CONTAINER means the grounds container was not put back after cleaning. Open the service door and insert it, making sure it sits correctly on the drip tray.
Also shown as INSERT GROUNDS CONTAINER
INSERT GROUNDS CONTAINER means the grounds container was not put back after cleaning. Open the service door and insert it, making sure it sits correctly on the drip tray.
Pull forward on the hot water and steam spout.
The prompt stays with the container clipped in.
Checks you have ticked / saved in this browser

Pull forward on the hot water and steam spout.

JennAir's page asks only for this.

The overview page says the sensor needs the container properly clipped into its compartment on the drip tray.
Push the tray fully home, then close the service door.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit


A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The drip tray catches rinse and drain water and the grounds container holds spent pucks.
Read the definitionAfter cleaning, the grounds container has not been replaced.
Read the supporting manualOpen the service door and insert the grounds container.
Read the supporting manualThe overview page says the sensor switch needs the container clipped properly on the drip tray before the assembly goes in.
Read the supporting manualIf the prompt stays after you refit the container, the sensing may be the cause. JennAir prints no part for it.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 2758 / PH 2758 (built-in coffee maker)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-11-06; PH 10313 / PH 10313 (built-in coffee maker, display messages)
Scope: JennAir built-in coffee maker. Read from the JennAir Product Help message page for this code and checked against the overview page of display messages (November 2026).
JennAir says the container was not replaced after cleaning. Refit it and the prompt should clear.
The overview page says a sensor switch detects the container, so it must be seated, not just resting.
Yes. The container clips onto the tray, and the tray must be pushed all the way in.
No change is expected. If the prompt returns, book a visit.
Code or symptom, part, service call
EMPTY GROUNDS CONTAINER means the container is full and has to be emptied and cleaned. Switch the coffee system off with On/Standby, take out the cup tray and grounds container, empty it and wipe out the residue.
A display prompt halts brewing until you fix the condition: refill and seat the tank for FILL TANK, empty the grounds container, reseat the brewing unit, close the service door, or adjust a too-fine grind. DESCALE needs the descaling cycle. GENERAL ALARM means clean the inside.
The drip tray catches rinse and drain water and the grounds container holds spent pucks. JennAir says to empty the tray before its red float rises above the cup grid, and to empty the grounds whenever the tray comes out.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.