What it means
With E11 the control board received a problem report from the gas sensor. The sensor or its wiring may be the cause. Shut off the microwave breaker for a minute, switch it back on and see whether E11 comes back.
JennAir microwave E11 / Sensors
With E11 the control board received a problem report from the gas sensor. The sensor or its wiring may be the cause. Shut off the microwave breaker for a minute, switch it back on and see whether E11 comes back.
Also shown as E11
With E11 the control board received a problem report from the gas sensor. The sensor or its wiring may be the cause. Shut off the microwave breaker for a minute, switch it back on and see whether E11 comes back.
Switch off the microwave breaker, wait, then switch it on.
E11 returns after the reset.
Checks you have ticked / saved in this browser

Switch off the microwave breaker, wait, then switch it on.

JennAir asks you to confirm E11 does not show again.

Try a short cycle and see whether it behaves normally.

The page does not say which features use the gas sensor, so note what you were doing when E11 appeared.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit


A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The control board received a problem report from the gas sensor.
Read the supporting manualShut the microwave breaker off for a minute, turn it on and keep watching the microwave for the next minute.
Read the supporting manualThe page does not tie E11 to a gas supply. If you ever smell gas, leave the home and call your gas utility from outside.
Read the supporting manualWhen the code returns. The sensor and wiring need testing.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9581 / PH 9581 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
JennAir names it as the part that reported the problem. The page does not describe its function further.
The page treats E11 as a sensor or wiring problem. If you smell gas, leave and call your gas utility from outside.
It can clear a one-off. If E11 is back, book a visit.
E24 lists the gas sensor among four possible parts for an overheat condition. E11 names it alone.
Code or symptom, part, service call
With E24 the cavity registered an overheat reading of 500 F (260 C). JennAir lists the thermal sensor, the gas sensor, the board or the wiring. Turn the microwave breaker off for a minute and on again.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.