What it means
SE points at the keypad, also called the user interface, or at its wiring. Turn the microwave breaker off for a minute, turn it on, and keep the microwave oven in view for a minute.
JennAir microwave SE / Keypad
SE points at the keypad, also called the user interface, or at its wiring. Turn the microwave breaker off for a minute, turn it on, and keep the microwave oven in view for a minute.
Also shown as SE
SE points at the keypad, also called the user interface, or at its wiring. Turn the microwave breaker off for a minute, turn it on, and keep the microwave oven in view for a minute.
One minute off, then on.
SE returns after the reset.
Checks you have ticked / saved in this browser

One minute off, then on.

Check SE does not return in the first minute.

Press a few and check each responds.

A key held down by grease or a hand towel can look like a keypad error. Wipe the panel.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The keypad is the key panel on the front of a JennAir over-the-range microwave.
Read the definitionThe keypad, called the user interface, or its wiring is the problem.
Read the supporting manualSwitch the breaker off for a minute, turn it on and stay at the microwave oven for a minute.
Read the supporting manualE03 describes a report from the keypad to the board; SE states the keypad or wiring problem.
Read the supporting manualIf SE returns after a reset.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2023-08-16; PH 9579 / PH 9579 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
JennAir does not spell it out. The page says it indicates a keypad or wiring problem.
Both point at the keypad. They are separate entries.
The page does not say. A wipe of the panel is a harmless first check.
Book a visit and tell us which keys misbehave.
Code or symptom, part, service call
With E03 the control board received a problem report from the keypad, which JennAir also calls the user interface. The keypad or its wiring may be the cause. Turn off the breaker that serves the microwave, leave it a full minute, then switch it back on and see whether E03 returns.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
The keypad is the key panel on the front of a JennAir over-the-range microwave. JennAir also calls it the user interface or touch pad, and three codes name it: E03, F9Q1 and SE. Its single step is a sixty-second power-down, followed by a check that keys respond.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.