What it means
F4 E3 names the microwave exhaust air temperature sensor or its wiring on a JennAir wall oven. Cycle the breaker for sixty seconds; if the code stays away, keep an eye on the vent airflow.
JennAir oven F4E3 / Microwave (combination oven)
F4 E3 names the microwave exhaust air temperature sensor or its wiring on a JennAir wall oven. Cycle the breaker for sixty seconds; if the code stays away, keep an eye on the vent airflow.
Also shown as F4E3
F4 E3 names the microwave exhaust air temperature sensor or its wiring on a JennAir wall oven. Cycle the breaker for sixty seconds; if the code stays away, keep an eye on the vent airflow.
Check nothing blocks the exhaust opening of the oven.
F4 E3 returns after the reset.
Checks you have ticked / saved in this browser

Check nothing blocks the exhaust opening of the oven.

Restore it and run a brief microwave test.

With the microwave running, you should feel air leaving the vent.

If F4 E3 returns, stop using the microwave.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It measures the temperature of the air leaving the microwave section so the control can react to heat. JennAir lists it or the wiring for F4 E3.
Read the supporting manualA blocked vent can raise the temperature the sensor sees. The page does not say so, but clearing a blocked vent is a harmless step.
Read the supporting manualF8 E4 also names an exhaust fan air temperature sensor on wall ovens. The two codes are separate pages.
Read the supporting manualOnly the microwave side is named. Judge by how the main oven behaves.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13349 / PH 13349 (wall oven)
PH 13349: F4E3, wall-oven.
No. It sits in the airflow path behind panels.
JennAir does not say so; still, clear the vent.
Mention it when you book.
The page does not say so.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.