What it means
FEE7 on a JennAir freestanding range names the main cavity broil element or its wiring. Let the oven cool, reset the breaker for about a minute and test with a short broil only if the oven otherwise behaves.
JennAir oven FEE7 / Heating element
FEE7 on a JennAir freestanding range names the main cavity broil element or its wiring. Let the oven cool, reset the breaker for about a minute and test with a short broil only if the oven otherwise behaves.
Also shown as FEE7
FEE7 on a JennAir freestanding range names the main cavity broil element or its wiring. Let the oven cool, reset the breaker for about a minute and test with a short broil only if the oven otherwise behaves.
Broil elements sit near the roof of the cavity and stay hot.
FEE7 returns after the reset.
Checks you have ticked / saved in this browser

Broil elements sit near the roof of the cavity and stay hot.

Look for visible damage on the upper element. Do not touch or bend it.

Restore.

If bake works, the code is probably limited to broil.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
On JennAir ranges, FEE6 names the main cavity bake element and FEE7 the main cavity broil element, each with its wiring.
Read the definitionIt is the upper heating element used for broiling and sometimes for browning. JennAir names the main cavity broil element, or its wiring, for FEE7.
Read the supporting manualFEE6 is the bake element. FEE7 is the broil element. The two together cover the heating of the main cavity.
Read the supporting manualPossibly. The page does not say, so try a bake test and watch.
Read the supporting manualJennAir prints FEE8 as reset-only with no cause. Do not assume it is related.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-01-08; PH 13469 / PH 13469 (range)
PH 13469: FEE7, range.
No. It means the main cavity broil element or its wiring is a possible trouble spot. Let the oven cool, reset the breaker and test a bake before assuming the whole oven is affected.
Avoid broiling until it has been checked. The code names the broil element or its wiring, so test a short bake first and book a visit if the code returns after the reset.
No. The page lists the element or its wiring as the trouble spot but gives no owner steps. Inspect it only with the oven cold, and do not touch or bend it.
FEE6 is the bake element and FEE7 is the broil element, the upper one. Together they cover heating of the main cavity, so a working bake test suggests the code is limited to broil.
Code or symptom, part, service call
FEE8 is a reset-only message on a JennAir freestanding range; the page names no part. Cycle the breaker for a single minute, restore power and monitor the oven for a minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
On JennAir ranges, FEE6 names the main cavity bake element and FEE7 the main cavity broil element, each with its wiring. The pages offer one owner step: a one-minute breaker reset. An element that stays cold afterwards needs a technician with the power off.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.