What it means
PUSH or PSH on a JennAir range or wall oven means you chose a function and did not press START within five seconds. Press START soon after choosing; after one minute without it the function is canceled.
JennAir oven PUSH or PSH / Control message
PUSH or PSH on a JennAir range or wall oven means you chose a function and did not press START within five seconds. Press START soon after choosing; after one minute without it the function is canceled.
Also shown as PUSH or PSH
PUSH or PSH on a JennAir range or wall oven means you chose a function and did not press START within five seconds. Press START soon after choosing; after one minute without it the function is canceled.
Pick bake, broil or the cycle you wanted.
START does not work or PUSH keeps returning after pressing START.
Checks you have ticked / saved in this browser

Pick bake, broil or the cycle you wanted.

The prompt appears when you wait longer.

If it does nothing, note that for a technician.

This is a prompt, not an error.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It is asking you to confirm the choice by pressing START. If you ignore it, PUSH or PSH stays up for a while.
Read the supporting manualJennAir says that after one minute without START the function is canceled and you begin again.
Read the supporting manualYes, both pages carry the same behavior. Only the spelling differs by display.
Read the supporting manualIf START does nothing, or PUSH appears even after you pressed it.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-07; PH 13125 / PH 13125 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13258 / PH 13258 (wall oven)
PH 13125, 13258: PUSH-OR-PSH, range/wall-oven.
No. It is a prompt.
That is the window JennAir prints.
No, it is the same prompt on a smaller display.
Yes, that suggests a keypad or control issue.
Code or symptom, part, service call
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.