Model-specific code library
JennAir oven Meat probe codes
5 printed codes in this group: 3d31, 3d32, 3d41, F3E4, F8.

Meat probe codes
JennAir's page for 3d31 has you check the meat probe is pushed all the way into its receptacle, and names no failed part. Try a one-minute breaker cycle, then look for the code for 60 seconds.
Owner checks firstOn a range or wall oven, 3d32 is a prompt about the meat probe seat: JennAir blames no component. Try a 60-second power cycle, then watch for the code for 60 seconds.
Owner checks firstJennAir's page for 3d41 asks you to confirm the meat probe is fully seated in its receptacle; it names no part at all. Try a 60-second breaker cycle, then look for the code for a minute.
Owner checks firstF3 E4 on a JennAir freestanding range or wall oven is usually a dislodged meat probe, and on some wall ovens a roll-out power attachment that has come unplugged. Reseat the probe or attachment, then reset at the breaker for 60 seconds.
Owner checks firstPlain F8 on a JennAir freestanding range asks you to push the meat probe fully into its receptacle, then reset the breaker for sixty seconds. On a steam oven the F8 page is a reset only. Seat the probe first, then reset.
Owner checks first