Model-specific code library
JennAir oven Control message codes
6 printed codes in this group: Call Service, Feature Not Available or Fault Detected, Locked, Lock or Loc, Press Cancel to Reset, Probe or Insert Probe, PUSH or PSH.

Control message codes
Call Service on a JennAir oven means the control detected an error. Press Cancel first. If the message stays, switch the breaker off for one minute, turn it back on, start a bake cycle and watch the oven for a minute. If it returns, book a technician.
Reset, then bookFeature Not Available or Fault Detected scrolls across a JennAir range or wall oven display when the control found an error while you were setting a cook cycle. Follow the text on screen, then reset power at the breaker for 60 seconds.
Reset, then bookLocked, Lock or Loc on a JennAir range or wall oven means the control lock is on: the pads are shut down and the door is locked to prevent unintended use. Touch and hold START/ENTER for five seconds to unlock.
Information onlyPress Cancel to Reset appears on a JennAir range or wall oven when the oven has detected an error. Press CANCEL; if the message stays, throw the breaker that feeds the oven for 60 seconds, restore it and run a bake cycle to see if it stays away.
Reset, then bookProbe or Insert Probe on a JennAir range or wall oven means the control is waiting for a signal from the meat probe. Put the probe in the food and push it all the way into the probe jack.
Owner checks firstPUSH or PSH on a JennAir range or wall oven means you chose a function and did not press START within five seconds. Press START soon after choosing; after one minute without it the function is canceled.
Information only