Model-specific code library

JennAir oven Display message codes

8 printed codes in this group: C (Celsius), CAL, Demo Mode, ES or E5, Flashing Time or POWER LOSS, Lo, Pre, Sabbath.

Single built-in wall oven in a dim kitchen with a lit display, closed door and a striped hand towel draped over the handle.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Display message codes

C (Celsius)

A C on a JennAir oven display means the temperature scale is set to Celsius. JennAir's cooking appliance chart lists it as a display setting, not an error. While the oven reads in Celsius a 260 limit applies on the display, so nothing is broken when you see it.

Information only
CAL

CAL on a JennAir oven display is the calibration feature, not an error. JennAir's cooking appliance chart describes it as the function that lets you adjust the oven temperature. Read your owner's manual before changing anything, because a bad offset makes every bake run off.

Information only
Demo Mode

Demo Mode lets a JennAir oven show its controls without heating, and an oven left in it will not work. On a range, press SETTINGS/CLOCK until DEMO MODE appears and turn it off with the 1 key. On a wall oven choose Tools, INFO, Store Demo Mode, then OFF.

Information only
ES or E5

ES or E5 on a JennAir range display shows that Energy Save mode is on. On some models the display shows ES and On twice after five idle minutes, then goes blank until a key is pressed or the door is opened. JennAir does not treat it as an error.

Information only
Flashing Time or POWER LOSS

A flashing time, 12:00, POWER LOSS or Enter Time on a JennAir range or wall oven means power was interrupted. Press CANCEL to clear the display, then set the clock.

Information only
Lo

Lo on a JennAir freestanding range's display after you start the oven is a status, not an error: it says the oven is below 170 degrees F. Give it time to warm; the reading becomes a number as the oven heats.

Information only
Pre

Pre on a JennAir freestanding range's display after you start the oven is a status, not an error: the oven is preheating. The display moves to a number as the cavity warms; wait for the signal that preheat is done.

Information only
Sabbath

Sabbath, Sab, 5Ab, 5A7 or 5A6 on a JennAir range or wall oven means Sabbath Mode is on. It keeps the oven in a Bake setting until turned off and disables other cooking and cleaning cycles, tones and timers. Cancel it from the control as your Owner's Manual describes.

Information only

Let’s take care of it.

Something on the display?
Send us the details.