Model-specific code library
JennAir oven Wi-Fi connection codes
5 printed codes in this group: FC, FCE1, FCE2, FCE3, FCE7.

Wi-Fi connection codes
JennAir prints no bare FC. FC E1 to E9 are connected-appliance codes on ranges and wall ovens: E1 to E3 and E7 say the oven could not reach your router, E4 and E5 name the Wi-Fi antenna, E6 and E9 the Wi-Fi power module, and E8 is a registration entry error. Start with the home network.
Owner checks firstFC E1 on a JennAir range or wall oven means the appliance could not connect to your router, with poor signal, a failed router, the Wi-Fi module or its wiring as possible causes. Restart the router and the oven, then check the signal at the oven.
Owner checks firstFC E2 uses the same wording as FC E1 on a JennAir range or wall oven: the appliance could not connect to the router. Run the two-step power sequence JennAir prints, router first and oven second, and then retry the connection.
Owner checks firstFC E3 matches FC E1 and E2 on a JennAir range or wall oven: the oven could not connect to the router. Check the signal where the oven stands and restart the router before touching the oven.
Owner checks firstFC E7 says the oven did not connect to your router, in plainer words than E1 to E3, with no cause list on the page. Check the home network and the signal, then reset the breaker for about a minute.
Owner checks first